Skip to content

Planet Audio AC600.2 Anarchy 600W 2-Channel Full Range Car Amplifier

Availability:
Low stock
SKU PLA-AC600.2
Designed in the USA
Features variable low pass and high pass crossovers
Features variable input gain controls
Variable 0 to +18dB Bass Boost Control
Class A-B operation
Bridgeable outputs
Tri-Mode capable
MOSFET PWM (Pulse Width Modulated) Power Supply
2 Ohm stable stereo operation with output power increase
Thermal and speaker short protection
Soft turn-on circuit
Remote turn-on/turn-off circuit
Fixed high pass crossover(s)
Chrome-plated RCA low level and high level inputs
LED power and protection indicators
Black anodized heatsink
Authorized Dealer

About 2 Ohm Operation

Your Anarchy amplifier has been designed to operate efficiently at loads down to 2 Ohms. This means that you can install four 8 Ohm speakers per channel, when using parallel wiring.

Increasing the number of woofers per channel at low frequencies (below 100Hz) produces an acoustic coupling effect. This accoustic coupling effect increases your power output by about 3dB per speaker, or the equivalent of an additional 10W per speaker.

When operating at 2 Ohms, the amplifiers will increase their output power by approximately 50%. The current draw will also increase by about the same amount, so be sure you have enough current to run the amplifiers into a 2 Ohm load.

If you lack adequate current, your music reproduction will be distorted.

Max Power into 4 Ohms: 150W x 2
Max Power into 2 Ohms: 300W x 2
Max Bridged Power into 4 Ohms: 600W x 1
Min. Speaker Impedance: 2 Ohm Stereo; 4 Ohm Mono Bridged
THD: 0.01%
Frequency Response: 20Hz-20kHz
Signal-to-Noise Ratio: 102dB
Channel Separation: 90dB
Damping Factor: 125+
Crossover Range (Low Pass): 45Hz-90Hz
Crossover Range (High Pass): 80Hz
Bass Boost: Variable 0 to +18dB
Fuse Rating: 20A
Dimensions: 10" x 2-9/16" x 7-12/25" (254mm x 65mm x 190mm)

ANARCHY Amplifier
High Input Cable with Connector
4 x Mounting Screws
User's Manual